Index
- BMSBattery S series
 - BMSBattery S06S
 - S06ST (torque sensor version)
 - S06S-BL (Bluetooth version)
 - PWM signals
 - Phase B current signal
 - Throttle
 - BMSBattery S06SC
 - BMSBattery S12S
 - BMSBattery bottle battery controller
 - LCD control panel
 - Kunteng mobile app
 - Bluetooh
 - How to open the controller and solder the programming header
 - Hardware mods
 - Other controllers
 - BMSBattery S06P
 - Kunteng 18 mosfets motor controller
 - Lishui motor controllers
 - JinHui motor controllers
 - GreenEBikeKit
 
- Torque speed
 - Motor control scheme of S06S controller
 - BLDC 6 steps
 - PWM schemes
 - So, Which PWM Technique is Best? (Part 1)
 - So, Which PWM Technique is Best? (Part 2)
 - So, Which PWM Technique is Best? (Part 3)
 - So, Which PWM Technique is Best? (Part 4)
 - So, Which PWM Technique is Best? (Part 5)
 - So, Which PWM Technique is Best? (Part 6)
 - So, Which PWM Technique is Best? (Part 7)
 - PWM control and Dead Time Insertion
 - Low inductance motors
 - Throttle Control Modes
 - Phase angle FOC
 - PWM frequency VS motor eRPM
 - Sinusoidal Control of BLDCM with Hall Sensors Based
 - Self-Learn Hall Sensor Calibration Mode
 - STM8S105 Alternatives
 - PID algorithm - negative output values
 - Regeneration
 - FOC
 
Datasheets and application notes
- STM8S105C6T6
 - Endless-sphere.com forum messages
 - 2017.04.25 - Initial forum message
 - 2017.05.08 - First flash and debug on a dev board
 - 2017.05.18 - First code flashing and running
 - 2017.05.20 - more new information
 - 2017.08.23 - SxxP versus SxxS versus LSW-675
 - 2017.09.01 - Trying to figure out an algorithm to automatically adjust ui8_position_correction_value
 - 2017.09.02 - How to do FOC on the BMSBattery S06S/Kunteng STM8 motor controllers
 - 2017.09.03 - more ideas about zero crossing for FOC
 - 2017.09.05 - measuring IQ current and manually adjusting position_correction_value
 - 2017.09.15 - our OpenSource firmware efficiency compared to Lishui 12 FET FOC
 - 2017.09.19 - measuring motor current
 - 2017.10.23 - FOC and no FOC comparison
 - 2018.01.10 - How to measure FOC_READ_ID_CURRENT_ANGLE_ADJUST
 - 2018.02.20 - Reading motor phase current from the DC link current (shunt)
 
LCD control panel
User manuals
| Linked file: S-LCD3_Manual_V2.pdf | 
| Linked file: S-LCD3-Operation-Manual.pdf | 
As can be seen on the following pictures, the LCD uses the same microcontroller reference from the motor controller.
LCD driver IC:
| Linked file: TM1622.pdf | 
Pictures from inside of LCD5:
