Index

About the project

  1. about this documentation in HTML
  2. License

Controllers

  1. BMSBattery S06x
    1. LCD control panel
      1. LCD protocol
    2. S06S
      1. PWM signals
        1. very low speed - 6 steps
        2. low speed up to max speed - sineware
    3. S06P
      1. various info
        1. 01
        2. 02
  2. BMSBattery S12S
  3. BMSBattery bottle battery controller
  4. GreenEBikeKit
  5. Kunteng 18 mosfets

Datasheets and application notes

  1. STM8S105C6T6
    1. Interrupts
  2. Alternatives

Development tools

  1. STLinkV2 - Flash/program/debug hardware
  2. Flash and debug connector on S Series controller
  3. Debug OpenOCD and Eclipse
    1. stm8-binutils-gdb
  4. Flash programming
  5. C library
  6. Various resources
    1. Printf example

Motor control

  1. Motor control scheme of S06S controller
  2. BLDC 6 steps
  3. PWM schemes
    1. So, Which PWM Technique is Best? (Part 1)
    2. So, Which PWM Technique is Best? (Part 2)
    3. So, Which PWM Technique is Best? (Part 3)
    4. So, Which PWM Technique is Best? (Part 4)
    5. So, Which PWM Technique is Best? (Part 5)
    6. So, Which PWM Technique is Best? (Part 6)
    7. So, Which PWM Technique is Best? (Part 7)
  4. PWM control and Dead Time Insertion
  5. Low inductance motors
  6. Throttle Control Modes

Various

  1. Endless-sphere.com forum messages
    1. 2017.04.25 - Initial forum message
    2. 2017.05.08 - First flash and debug on a dev board
    3. 2017.05.18 - First code flashing and running
    4. 2017.05.20 - more new information
  2. How to unlock proteced read memory
  3. STM8S003 board
  4. LOG
    1. 2017.06.19 - SVM current waveforms

Clipping

  1. 2017.05.22 - Hackaday Links: May 21, 2017

Smart BMS with bluetooth

S06P


The S06P controller don't do sine wave motor control but just 6 steps. When compared to the S06S controller:
• don't have the phase current sensor (the place is on the board but is empty)
• have a secondary board that connects to the same pins as hall sensors:
◇ have a STM8S003F3P6 (with available header to be programmed)
◇ have an LM339
◇ I would say this board does BEMF signal output to simulate the hall sensors signal, just like on the KU63 controller circuit

Pictures


images/39-1.png

images/39-2.png